3D print cost calculator
Drop an STL, OBJ, PLY, 3MF or GLB and see how many grams, how many metres of filament and how much it will cost — for FDM or resin, with your infill, walls, price and electricity. It runs in your browser: the file is never uploaded.
Drop a 3D model here, or click to choose
STL · OBJ · PLY · 3MF · GLB 🔒 Measured locally — the file never leaves your computerElectricity, filament diameter and printer fit
An estimate for planning and quoting. Your slicer knows the exact toolpaths, supports and brim — use its figure for the final number.
How the estimate works
The calculator measures the model's volume and surface area straight from the triangles. For FDM it treats the outside as a shell as thick as your walls and top and bottom layers, fills the rest with your infill percentage, adds a percentage for supports and waste, and multiplies by the material's density to get grams.
Cost is grams × price per kilogram, plus electricity if you enter the print time from your slicer (hours × printer watts × price per kWh). For resin, a solid part uses its full volume; a hollow part uses a shell of the wall thickness you choose.
Typical infill
Decorative prints and figurines: 5–15%. Everyday functional parts: 15–25%. Strong mechanical parts: 30–50%. Above about 50%, extra walls usually add strength more efficiently than more infill.
Walls and shell
Two walls with a 0.4 mm nozzle are about 0.8 mm; with top and bottom layers, 1.0–1.6 mm is a good average shell. Raise it if your slicer reports more material than this estimate.
Densities
PLA about 1.24 g/cm³, PETG 1.27, ABS 1.04, ASA 1.07, TPU 1.21. Standard resin is about 1.1–1.2. Check your spool or bottle for the exact value.
Units
STL has no units. If the weight looks absurd, the file was probably saved in metres or inches — change "Units in the file".
Need the model in CAD?
To edit a scan, a sculpt or an AI-generated model in Fusion 360, SolidWorks or Onshape, turn the mesh into a STEP made of smooth surfaces instead of triangles. Mesh to STEP → · AI 3D model to STEP →
FAQ
Is my file uploaded?
No. The model is read and measured entirely in your browser; the file never leaves your computer.
How accurate is the estimate?
It is usually close enough for quoting and planning, but it is an estimate: walls are modelled as a shell of fixed thickness and infill as a fraction of the rest. Your slicer knows the exact toolpaths, supports and brim, so use its figure for the final number.
Why does my slicer show a different weight?
Slicers add supports, brims and purge material, use the real number of walls and top and bottom layers, and some infill patterns are denser than their percentage suggests. Adjust the shell thickness and waste percentage here to match your slicer for similar parts.
Can it calculate resin prints?
Yes. Switch to resin, choose solid or hollow with a wall thickness, and add a percentage for supports and waste.
Why does it ask about units?
STL files store numbers without units. Most are in millimetres, but files from some apps and AI 3D generators are in metres or inches, which would make the weight wildly wrong. GLB files are in metres by definition, and for other files the calculator suggests metres when the model looks too small. Check the size shown in the results.