Free tool · Split for printing

STL splitter

Model too big for your 3D printer? Cut it into pieces that fit your build plate, with every cut face closed so each piece prints as a solid — then download them all as one ZIP. It runs in your browser: the file is never uploaded.

Drop a 3D model here, or click to choose

STL · OBJ · PLY · 3MF · GLB 🔒 Split locally — the file never leaves your computer
Reading…
Units in the file
Printer
Pieces along each axis

Alignment holes
Rather scale it down to fit? Resize it →

When to split a model

Bigger than the build plate

Helmets, cosplay props, large vases and architecture models often exceed 250 mm. Split them and print the pieces one after another.

Too tall for the printer

Set X and Y to 1 and raise Z to cut a tall model into stacked sections only.

Shorter, safer prints

Several smaller prints fail less often than one 30-hour print, and a failed piece costs far less to redo.

Better orientation

A split piece can often be laid on its flat cut face, which needs fewer supports than the whole model.

How it works

The model is cut by flat planes along X, Y and Z into equal parts, as few as fit your printer with the clearance you set. Triangles that cross a plane are split in two, and the outline where each plane meets the model is traced and filled in to close the cut face — including hollow sections, such as a cut through a ring or a part with an internal cavity, where the fill has holes in it.

Alignment holes go only where the cut face has room around them — at least the hole radius plus 1.2 mm from any edge or other cut — and where the material behind the face is deep enough, so a hole never breaks through. Each cut gets up to two holes, as far apart as possible, so the pieces cannot twist.

Each piece stays in its original position, so the files line up again when you open them together. Pieces are only closed if the model was: the tool checks the model first and tells you if its surface has holes.

FAQ

Is my file uploaded?

No. The model is read, cut and saved entirely in your browser; the file never leaves your computer.

Are the pieces solid?

Yes, if the model was watertight. Every cut face is filled in, including cuts through hollow parts and holes, so each piece is a closed solid your slicer can print. If the model has holes in its surface, some cut faces cannot be closed; the tool tells you and links to the free STL repair tool.

How do I put the pieces back together?

Glue the flat cut faces together: superglue or epoxy for PLA, solvent welding for ABS. To line them up exactly, tick Add holes for alignment pins: matching holes are made in both faces, and a short piece of 1.75 mm filament or a dowel pushed into them keeps the pieces aligned while the glue sets. The pieces keep their original position, so you can also open them together in your CAD or slicer to check the fit.

Where are the cuts made?

The model is divided into equal parts along each axis, using as few pieces as fit your printer with the clearance you set. You can change the number of pieces along X, Y and Z yourself, for example to split a tall model only horizontally.

Which formats can I use?

You can open STL, OBJ, PLY, 3MF and GLB. Each piece is saved as a binary STL in millimetres; Download all gives you one ZIP file with every piece.