3D printability check
Drop an STL, OBJ, PLY, 3MF or GLB and see which overhangs need support and which walls are too thin, how the part sits on the bed, whether it fits your printer, and which way up needs the least support. It runs in your browser: the file is never uploaded.
Drop a 3D model here, or click to choose
STL · OBJ · PLY · 3MF · GLB 🔒 Checked locally — the file never leaves your computerWhat it checks
Overhangs
Downward-facing surfaces flatter than your overhang limit need support. They are shown in red, with their share of the surface.
Thin walls
Walls thinner than the minimum for your process are shown in purple. They may not print, or break when you remove supports.
Bed contact
The faces that rest on the build plate, in blue. A part that touches the bed with only a small area may come loose during printing.
Will it stand?
Figures and display pieces must not tip over. The center of gravity and the base it stands on are shown in 3D, with how far the part can tilt before it falls.
Orientation and size
The tool tries all six sides facing up and tells you if another one needs much less support, and whether the part fits your printer.
How it works
A surface needs support when it faces downwards at a shallower angle than the overhang limit, measured from vertical. Faces lying on the build plate are not counted. Wall thickness is measured by casting a short ray from each triangle straight into the part: if it reaches the opposite surface within the minimum thickness, that spot is too thin.
The check works on the triangles of your file, so it does not know about the supports, bridges or infill your slicer will add. Use it to catch problems and choose an orientation before you slice. The model should be watertight for the wall check to be reliable; the STL repair tool closes holes.
FAQ
Is my file uploaded?
No. The model is read and checked entirely in your browser; the file never leaves your computer.
What overhang angle should I use?
Most FDM printers print overhangs up to about 45° from vertical without support; well-tuned printers with good cooling manage 50–60°. Resin printers also need support under overhangs. SLS and other powder processes need no support at all.
How thin can walls be?
For FDM, at least two extrusion widths: about 0.8 mm with a 0.4 mm nozzle. Resin printers manage about 0.5 mm, SLS about 0.7 mm. Thinner walls may not print at all or break easily.
Will the printed part stand up on its own?
The tool finds the center of gravity — for FDM, weighted by the solid outer walls and your infill — and checks whether it sits over the area the part stands on. It shows how far the part can tilt before it falls, and draws the base and a plumb line in 3D. It assumes a uniform material and a part standing this way up on a flat table.
Does it replace my slicer?
No. It shows problems early, before you slice, and helps choose an orientation. Your slicer still decides the exact supports, and it also catches problems this check does not look for, such as very small holes and bridges.